(UART) An integrated circuit
used for serial communications, containing a transmitter (parallel-to-serial converter) and a receiver (serial-to-parallel converter), each clocked separately.
The parallel side of a UART is usually connected to the bus
of a computer. When the computer writes a byte to the UART's transmit data register (TDR), the UART will start to transmit it on the serial line. The UART's status register contains a flag
bit which the computer can read to see if the UART is ready to transmit another byte. Another status register bit says whether the UART has received a byte from the serial line
, in which case the computer should read it from the receive data register (RDR). If another byte is received before the previous one is read, the UART will signal an "overrun" error via another status bit.
The UART may be set up to interrupt
the computer when data is received or when ready to transmit more data.
The UART's serial connections usually go via separate line driver and line receiver integrated circuits
which provide the power and voltages required to drive the serial line and give some protection against noise on the line.
Data on the serial line
is formatted by the UART
according to the setting of the UART's control register. This may also determine the transmit and receive baud rates if the UART contains its own clock circuits or "baud
rate generators". If incorrectly formated data is received the UART may signal a "framing error" or "parity
Often the clock will run at 16 times the baud rate (bits per second) to allow the receiver to do centre sampling - i.e. to read each bit in the middle of its allotted time period. This makes the UART more tolerant to variations in the clock rate
("jitter") of the incoming data.
An example of a late 1980s UART was the Intel 8450. In the 1990s, newer UARTs were developed with on-chip buffers
. This allowed higher transmission speed without data loss and without requiring such frequent attention from the computer. For example, the Intel 16550
has a 16 byte FIFO
. Variants include the 16C550
, 16C650, 16C750
, and 16C850
The term "Serial Communications Interface" (SCI) was first used at Motorola
around 1975 to refer to their start-stop asyncronous serial interface device, which others were calling a UART.
See also bit bang
[Is this the same as an ACIA